2012 Lexus LS 460 Owners Manual - Page 213
2012 Lexus LS 460 Manual
Page 213 highlights
2-3. Operating the lights and windshield wipers Switching to high beam Turn the light switch to position. 2 When driving
215
2-3. Operating the lights and windshield wipers
2
When driving
■
The Automatic High Beam can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode.
■
Camera sensor detection information
●
High beam may not be automatically turned off in the following situations:
°
When oncoming vehicles suddenly appear from a curve.
°
When the vehicle is cut in front of by another.
●
High beam may be turned off if an oncoming vehicle that is using fog lights with-
out using the headlights is detected.
●
House lights, street lights, red traffic signals, and illuminated billboards or signs
may cause the high beam to turn off.
●
The following factors may affect the amount of time taken to turn high beam on
or off:
°
The brightness of headlights, fog lights, and tail lights of oncoming and pre-
ceding vehicles
°
Road conditions (wetness, ice, snow etc.)
°
The number of passengers and amount of baggage
●
High beam may be turned on or off when unexpected by the driver.
●
In the situations below, the system may not be able to correctly detect the sur-
rounding brightness levels, and may flash or expose nearby pedestrians to the
high beam. Therefore, you should consider turning the high beams on or off
manually rather than relying on the Automatic High Beam system.
Switching to high beam
Turn the light switch to
position.