2001 Lincoln Navigator Owner Guide 4th Printing - Page 98

Seating and safety restraints • Pull the seat release lever located on the lower right side of the seatback while pushing the seatback down into the seat cushion. • The seatback will latch into place. 4. Lift the seat release bar located at the center of the seat near the floor to release the floor latches. 5. While pulling up on the release bar, lift the seat up and out of the floor tubs and roll seat rearward. 6. With assistance, lift the seat out of the vehicle. Installing the third row seat Always latch the vehicle seat to the floor, whether the seat is occupied or empty. If not latched, the seat may cause injury during a sudden stop. When reinstalling a rear seat in your vehicle it must be placed in its original position. Improper installation of the seat will prevent correct use of the safety belts and could increase the risk of injury. Refer to the warning label on the seat belt. Before installing your third row seat, ensure that the detachable anchor tongues are stowed into the floor and the loose belts are stored out of the way. For proper latching, ensure that the floor tubs are clear of debris. From the rear of the vehicle, with the liftgate open: 1. With assistance, lift the seat into the rear of the vehicle and position front rollers onto the track. By rolling the seat forward, guide the seat positioners over the front pins of the floor tubs. 2. Guide the positioners around each pin and lower the seat. 98