2010 Lincoln MKZ Owner's Manual - Page 44
2010 Lincoln MKZ Manual
Page 44 highlights
Lights 15. Turn the headlamps on and make sure they work properly. If the headlamp was correctly aligned before you changed the bulb, you should not need to align it again. Lowbeam bulb replacement 1. Make sure headlamp switch is in OFF position, then open the hood. 2. Remove screw from oval splash shield access panel from the exterior wheel well area. Lift up and rearward to release a hidden finger attachment at the lower portion of the panel (Passenger side only). 3. From the exterior wheel well area reach arm through splash shield opening to access bulb socket (Passenger side only). 4. Remove the protective rubber cap from the housing by grabbing it and pulling rearward. 5. Remove the bulb socket by rotating it counterclockwise, then pulling it straight out of the lamp assembly. 6. Let go of the bulb socket and leave it dangling near the lamp housing (Passenger side only). 7. Reach over the front bolster in the engine area, with a tool if necessary, bring the bulb socket upwards into an unobstructed area to replace the bulb (Passenger side only). 8. Disconnect the electrical connector from the bulb socket and discard the old bulb socket. 9. Connect the new bulb socket to the electrical connector. 44 2007 Zephyr (378) Owners Guide (post-2002-fmt) USA (fus)