2012 Lincoln Navigator Owner Guide 1st Printing - Page 22
2012 Lincoln Navigator Manual
Page 22 highlights
Instrument Cluster OIL LIFE This displays the remaining oil life. An oil change is required whenever indicated by the message center and according to the recommended maintenance schedule. USE ONLY RECOMMENDED ENGINE OILS. To reset the oil monitoring system to 100% after each oil change perform the following: 1. Press and release SETUP to display "OIL LIFE XXX% HOLD RESET = NEW". 2. Press and hold RESET for two seconds and release to reset the oil life to 100%. Note: To change oil life 100% value to another value, proceed to Step 3. 3. Once "OIL LIFE SET TO XXX%" is displayed, release and press RESET to change the Oil Life Start Value. Each release and press will reduce the value by 10%. UNITS Displays the current units English or Metric. Press the RESET button to change from English to Metric. AUTOLAMP (SEC) This feature keeps your headlights on for up to three minutes after the ignition is switched off. Press the RESET button to select the new Autolamp delay values of 0, 10, 20, 30, 60, 90, 120 or 180 seconds. AUTOLOCK This feature automatically locks all vehicle doors when the vehicle is shifted into any gear, putting the vehicle in motion. Press the RESET button to turn autolock on or off. AUTOUNLOCK This feature automatically unlocks all vehicle doors when the driver's door is opened within 10 minutes of the ignition being turned off. Press the RESET button to turn autounlock on or off. RUNNING BOARDS (if equipped) This feature automatically deploys the side running boards for easy entry/exit from the vehicle or for cleaning. Press the RESET button to select the running boards setting as follows: •AUTO: the running boards will automatically deploy when a door is opened and automatically retract when the door is closed, 22 2012 Navigator (nav) Owners Guide, 1st Printing USA (fus)