2014 Lincoln MKS Owner Manual Printing 1 - Page 42

Safety Belts 41 Note: You can activate and deactivate the driver and front passenger Belt-Minder independently. When deactivating or activating one seating position, do not buckle the other position as this will terminate the process. Read Steps 1 - 5 thoroughly before proceeding with the programming procedure. Note: If you are using MyKey, you cannot disable Belt-Minder. Also, if the Belt-Minder has been previously disabled, it will be re-enabled during the use of MyKey. See the MyKey chapter. You can activate and deactivate this feature by performing the following procedure: Before following the procedure, make sure that: • the parking brake is set. • the transmission selector lever is in position P. • the ignition is off. • the driver and front passenger safety belts are unbuckled. 1. Switch the ignition on. Do not start the engine. 2. Wait until the safety belt warning light turns off (about one minute). 3. Wait 10 seconds after the safety belt warning light turns off. • Step 4 must be completed within 20 seconds after the completion of Step 3. 4. Buckle then unbuckle the safety belt three times at a moderate speed, ending in the unbuckled state. • After Step 4, the safety belt warning light will turn on for three seconds. 5. Within about seven seconds of the light turning off, buckle then unbuckle the safety belt. The safety belt warning light will blink. • This will disable the Belt-Minder feature for that seating position if it is currently enabled. • This will enable the Belt-Minder feature for that seating position if it is currently disabled. 2014 MKS (mks) Owners Guide gf, 1st Printing, April 2013 USA (fus)