2014 Lincoln MKT Owner Manual Printing 1 - Page 86

Locks The anti-scan feature will turn off after: • one minute of keypad inactivity • pressing the unlock button on the remote control • the ignition is turned on • unlocking the vehicle using intelligent access. 85 Unlocking and Locking the Doors To unlock the driver door: Enter the factory-set 5-digit code or your personal code. You must press each number within five seconds of each other. The interior lamps will illuminate. Note: All doors will unlock if the two-stage unlocking feature is disabled. Refer to Locking and Unlocking earlier in this chapter. To unlock all doors: Enter the factory-set code or your personal code, then press the 3•4 control within five seconds. To lock all doors: Press and hold 7•8 and 9•0 at the same time with the driver door closed. You do not need to enter the keypad code first. Displaying the Factory Set Code Note: You will need to have two programmed intelligent access keys for this procedure. To display the factory-set code in the information display: 1. Place the first programmed key in the backup slot inside the center console. The key ring must be at the top with the buttons facing toward the rear. 2. Press the START/STOP button once and wait a few seconds. 3. Press the START/STOP button again and remove the key. 4. Insert the second programmed key into the backup slot, then press the START/STOP button. The factory-set code will appear in the information display for a few seconds. Note: The code may not display until after any other warning messages first display. 2014 MKT (mkt) Owners Guide gf, 1st Printing, April 2013 USA (fus)