2015 Lincoln MKX Owner Manual Printing 1 - Page 199
2015 Lincoln MKX Manual
Page 199 highlights
198 Driving Aids System Limitations The BLIS® and CTA systems do have their limitations; situations such as severe weather conditions or debris build-up on the sensor area may limit vehicle detection. The following are other situations that may limit the BLIS®: • Certain maneuvering of vehicles entering and exiting the blind zone. • Vehicles passing through the blind zone at very fast rates. • When several vehicles forming a convoy pass through the blind zone. The following are other situations that may limit the CTA system: • Adjacently parked vehicles or objects obstructing the sensors. • Approaching vehicles passing at speeds greater than 15 mph (24 km/h). • Driving in reverse faster than 3 mph (5 km/h). • Backing out of an angled parking spot. False Alerts Note: If you connected a trailer to your vehicle the BLIS® system may detect the trailer causing a false alert. To avoid false alerts you may want to turn the BLIS off manually. There may be certain instances when either the BLIS® or CTA systems illuminate the alert indicator with no vehicle in the coverage zone; this is known as a false alert. Some amount of false alerts are normal; they are temporary and self-correct. System Errors If either system senses a problem with the left or right sensor, the BLIS® indicator in the information display will illuminate and remain on. Also, BLIND SPOT SYSTEM FAULT or CROSS TRAFFIC SYSTEM FAULT message will appear. When problems that may cause the left or right indicator not to illuminate, only the information display message faults appear. Switching the Systems Off and On One or both systems can be switched off temporarily by using the information display control; refer to the Information Display chapter. When you switch off the Blind Spot Information System, you will not receive alerts and the information display will display a system off message. The yellow alert indicator in the outside mirror will also flash twice. The system switches back on whenever you switch the ignition on.