2007 Mazda CX-7 Owner's Manual - Page 122

CX-7_8V28-EA-06B_Edition2 Page122 Monday, March 13 2006 5:5 PM Black plate (122,1) Knowing Your Mazda Doors and Locks To stop sliding partway, push any part of the tilt or slide switch. qEngine-off Moonroof Operation The moonroof can be operated for about 40 seconds after the ignition switch is turned from the ON position to the ACC or LOCK position with all doors closed. If any door is opened, the moonroof will be inoperable. NOTE Open Close Close Re-initializing If the battery had been disconnected during vehicle maintenance or for other reasons, the moonroof may not fully open or close. The moonroof's jam-safe function does not function while the moonroof is initializing. Carry out the following procedure to resume operation: 1. Turn the ignition switch to the ON position. 2. Push the rear of the tilt switch, to partially tilt open the rear of the moonroof. NOTE For engine-off operation of the moonroof, the switch must be pushed firmly throughout moonroof closure because the auto-closing function will be inoperable. qOpening/Closing the Moonroof from Outside The moonroof can be opened or closed from outside the vehicle after the doors and the liftgate are closed. WARNING Make sure the opening is clear before closing the moonroof: Closing the moonroof is dangerous. A person's hands, head, or even neck could be caught by the moonroof and result in serious injury or even death. This warning applies especially to children and pets. If the re-initialization procedure is performed while the moonroof is in the slide position (partially open) it closes before the rear tilts opens. 3. Repeat the procedure in Step 2. The rear of the moonroof tilts open to the fully open position, then closes a little. 3-46 Form No.8V28-EA-06B