2009 Mazda RX-8 Owner's Manual - Page 206
2009 Mazda RX-8 Manual
Page 206 highlights
Driving Your Mazda Switches and Controls NOTE FCC ID: NZLSTDHL3 CANADA:4112104541A This device complies with FCC rules part 15. Operation is subject to the following conditions: 1- This device may not cause any harmful interference and 2- This device must accept any interference that may be received including interference that may cause undesired operation. The HomeLink system provides 3 buttons which can be individually selected and programmed using the transmitters for current, on-market devices as follows: 1. Press and hold the two outer HomeLink buttons (buttons one and three) ― releasing only when the indicator light begins to flash (after 20 seconds). Do not hold the buttons for longer than 30 seconds and do not repeat step 1 to program a second and/ or third hand-held transmitter to the remaining two HomeLink buttons. 2. Position the end of your hand-held transmitter 2.5―7.5 cm (1―3 inches) away from the HomeLink button you wish to program while keeping the indicator light in view. 3. Simultaneously press and hold both the chosen HomeLink and hand-held transmitter buttons. Do not release the buttons until step 4 has been completed. NOTE Some gate operators and garage door openers may require you to replace this Programming Step 3 with procedures noted in the "Gate Operator/Canadian Programming" section. NOTE The programming will not be erased even if the battery is disconnected. qPre-programming the HomeLink System NOTE It is recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink for quicker training and accurate transmission of the radio-frequency signal. l l Verify that there is a remote control transmitter available for the device you would like to program. Disconnect the power to the device. qProgramming the HomeLink System CAUTION When programming a garage door opener or a gate, disconnect the power to these devices before performing programming, as continuous operation of the devices could damage the motor. 4. After the HomeLink indicator light changes from a slow to a rapidly blinking light, release both the HomeLink and hand-held transmitter buttons. NOTE If the HomeLink indicator light does not change to a rapidly blinking light, contact HomeLink at www.homelink.com or call 1800-355-3515 for assistance. 5-68