2002 Mercury Grand Marquis Owner Guide 1st Printing - Page 55
2002 Mercury Grand Marquis Manual
Page 55 highlights
Climate Controls Fan speed ( ) When AUTOMATIC is pressed, fan speed is adjusted automatically for existing conditions. You can override fan speed at any time. To control fan speed manually, use the thumbwheel to cancel automatic fan speed operation. Rotate the thumbwheel or press the steering wheel controls (if equipped) up for higher fan speed or down for lower fan speed. to The display will show indicate manual fan operation. OFF HI AUTOMATIC FLR • DEF DEF LO ˚F AUTO To return to automatic fan operation, press AUTOMATIC. Manual override controls The override controls are located at the bottom of the EATC and allow you to determine where airflow is directed. To return to full automatic control, press AUTOMATIC. F OFF HI AUTO OUTSIDE TEMP AUTOMATIC MAX A/C NORM A/C VENT FLOOR FLR • DEF DEF LO The air conditioning compressor can operate in all modes except FLOOR and VENT. It will also operate only when required when AUTOMATIC has been selected. However, the air conditioning will only function if the outside temperature is about 6°C (43°F) or higher. Since the air conditioner removes considerable moisture from the air during operation, it is normal if clear water drips on the ground under the air conditioner drain while the system is working and even after you have stopped the vehicle. • MAX A/C-Uses recirculated air to cool the vehicle. The temperature display will remain the same and air will be cooled based on the selected temperature. To exit, press AUTOMATIC or any other override controls. MAX A/C is noisier than NORM A/C but more economical and will cool the inside of the vehicle faster. Airflow is from the instrument panel registers. This mode can also be used to prevent undesirable odors from entering the vehicle. 55