2005 Mercury Mariner Owner's Manual - Page 54

Driver Controls • Remove the VELCRO pad (2) from the storage compartment door (3). • Place VELCRO (5) on aftermarket transmitter (6) opposite of actuator control (8). • Measure the thickness (4) of the aftermarket transmitter (6). • Remove the rubber actuator (1) from the storage compartment (7) by pulling the rubber actuator (1) forward and twisting at the same time. Note: The length of the rubber actuator (1) is critical. Use care in cutting it to length. If the rubber actuator (1) is cut too much the aftermarket transmitter (6) will not activate the garage door opener. If the rubber actuator (1) is cut too long, the storage compartment door (3) will not close properly. Excessive force to close the storage compartment door (3) may cause the door latch to break. • Per the table below, cut the rubber actuator (1) to the proper length based on the thickness (4) measured in the third step. Approximate Thickness of Transmitter (GDO) Cut to Bottom of inches mm Notch Less Than 1/4 6.35 No Cut 7/8 22.00 Notch 2 1.0 26.00 Notch 4 1-3/16 32.00 Notch 6 • Reinstall the rubber actuator (1) in the storage compartment (7) by twisting and pushing it back into the slot. • Install the transmitter (6) on to storage compartment door (3) aligning the actuator control (8) with the rubber actuator (1). Close the storage compartment door (3) to verify proper fit. Do not force 54 2005 Mercury Mariner (mrn) Owners Guide (post-2002-fmt) USA_English (fus)