2005 Mercury Mountaineer Owner Guide 3rd Printing - Page 73
2005 Mercury Mountaineer Manual
Page 73 highlights
Driver Controls Erasing HomeLinkா buttons To erase the three programmed buttons (individual buttons cannot be erased): • Press and hold the two outer HomeLink buttons until the indicator light begins to flash-after 20 seconds. Release both buttons. Do not hold for longer that 30 seconds. HomeLink is now in the train (or learning) mode and can be programmed at any time beginning with Step 2 in the "Programming" section. Reprogramming a single HomeLinkா button To program a device to HomeLink using a HomeLink button previously trained, follow these steps: 1. Press and hold the desired HomeLink button. Do NOT release the button. 2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink button, follow Step 2 in the "Programming" section. For questions or comments, contact HomeLink at www.homelink.com or 1-800-355-3515. ELECTRONIC COMPASS/TEMPERATURE DISPLAY (IF EQUIPPED) Outside air temperature The outside temperature display is contained in the instrument cluster and displays all the time. If equipped with the DATC climate control system, the outside temperature will be displayed there. For more information, refer to Dual automatic temperature control (DATC) in the Climate Controls chapter To turn the display off or change the display from English to metric see your dealer. 73 2005 Mountaineer (mnt) Owners Guide (post-2002-fmt) USA (fus)