2008 Mercury Grand Marquis Owner Guide 1st Printing - Page 91
2008 Mercury Grand Marquis Manual
Page 91 highlights
Locks and Security Note: Ensure the brake pedal is not 3 depressed during this sequence. Place the key in the ignition and 2 cycle from 1 (OFF/LOCK) to 3 (ON) 4 eight times in rapid succession within 10 seconds. After doors lock/unlock, press any control on all transmitters (up to four). After 1 pressing the control on each remote transmitter, the door will lock and unlock. If programming multiple remote transmitters, you must press the control buttons on each remote transmitter within 7 seconds of each other to remain in programming mode. When completed, turn the ignition to 1 (OFF/LOCK). All transmitters must be programmed at the same time. • When completed, turn the ignition to the 1 (OFF/LOCK) position and wait at least 20 seconds in order to use the recently programmed transmitter(s). • All transmitters must be programmed during the same programming cycle. A transmitter that is not programmed within the same programming cycle will be erased and will no longer operate your vehicle's locks. If this occurs, you will have to reprogram all the transmitters again, as you cannot just "add" a transmitter. Illuminated entry The interior lamps illuminate when the remote entry system is used to unlock the door(s) or sound the personal alarm. The illuminated entry system will turn off the interior lights if: • the ignition switch is turned to the 2 (ACCESSORY), 3 (ON) or 4 (START) positions, or • the remote transmitter lock control is pressed, or • after 25 seconds of illumination. The dome lamp control must not be set to the off position for the illuminated entry system to operate. The inside lights will not turn off if: • they have been turned on with the dimmer control, or • any door is open. The battery saver will shut off the interior lamps 30 minutes after the last door is closed, or after 10 minutes if the last door is left open. 91 2008 Grand Marquis (grn) Owners Guide (post-2002-fmt) USA (fus)