2008 Mercury Milan Owner Guide 1st Printing - Page 86

Driver Controls is displayed on the message center. To exit the zone setting mode press and release the RESET control. 8. Press the RESET control to start the compass calibration function. 9. Slowly drive the vehicle in a circle (less than 3 mph [5 km/h]) until the CIRCLE SLOWLY TO CALIBRATE indicator changes to CALIBRATION COMPLETED. This will take up to three circles to complete calibration. 10. The compass is now calibrated. Setup menu Press this control for the following displays: • System Check • Units (English/Metric) • Language • Easy entry/exit seat (if equipped) • Reverse sensing system (Park Assist) (if equipped) System check Selecting this function from the SETUP menu causes the message center to cycle through each of the systems being monitored. Pressing the RESET control cycles the message center through each of the systems being monitored. Some monitored systems show message only if a warning is present. The sequence of the system check report is as follows: 1. DOORS CLOSED 2. ENGINE TEMPERATURE 3. OIL PRESSURE 4. BRAKE FLUID LEVEL 86 2008 Milan (mln) Owners Guide (post-2002-fmt) USA (fus)