1998 Nissan Maxima Owner's Manual - Page 74
1998 Nissan Maxima Manual
Page 74 highlights
OPERATING THE TRANSMITTER To operate, simply press the appropriate button on the Integrated HomeLink Transmitter. The red indicator light illuminates while the signal is being transmitted. The effective transmission range of the Integrated HomeLink Transmitter may differ from your hand-held transmitter. flashes rapidly for 1 to 2 seconds, then remains on, your garage door opener has a rolling code system. To operate your rolling code garage door opener from your HomeLink Transmitter, follow these steps: 1. Program your hand held transmitter to the HomeLink Transmitter by following the procedures outlined above (if not yet programmed). 2. Program your garage door opener receiver to recognize your HomeLink Transmitter (The HomeLink Transmitter follows the same procedure to train to the receiver as your hand held transmitter did when it was first installed): a) Remove the cover panel from your garage door opener receiver. The receiver should be located by the garage door opener motor. b) Locate the training button on the garage door opener receiver. The exact location and color of the button may vary by garage door opener brand. If you have difficulty locating the training button, reference your garage door opener manual. If you have difficulty programming your garage door opener equipped Instruments and controls PROGRAMMING PROBLEM DIAGNOSIS Be sure to keep your original hand-held transmitter for possible reprogramming if necessary. ¼ Make sure batteries in the hand-held transmitter are fully charged. ¼ Hold your hand-held transmitter against the bottom surface of the Integrated HomeLink Transmitter so that you can still see the red indicator light. ¼ Hold buttons for duration of the programming without interruption. ¼ Rotate your hand-held transmitter endover-end and program again. For best results, place the end opposite the battery compartment against the Integrated HomeLink Transmitter when programming. SPA0609 ROLLING CODES (if so equipped) If your hand held transmitter appears to train to the HomeLink Transmitter, but does not open your garage door, and your garage door opener was manufactured after 1995, your garage door opener may have a code protected or rolling code feature. This type of system will change the code of your garage door opener every time you open or close your garage door. To determine if you have one of these systems, depress the button on the HomeLink Transmitter that you have just programmed. If the LED on the HomeLink Transmitter 2-29