2002 Nissan Pathfinder Owner's Manual - Page 167
2002 Nissan Pathfinder Manual
Page 167 highlights
accelerator pedal. Your vehicle will maintain the set speed. ¼ To pass another vehicle, depress the accelerator pedal. When you release the pedal, the vehicle will return to the previously set speed. ¼ The vehicle may not maintain the set speed when going up or down steep hills. If this happens, drive without the cruise control. To cancel the preset speed, follow any of these three methods: a) Push the cancel switch; The SET light will go out. b) Tap the brake pedal; The SET light will go out. c) Turn the main switch off. Both the CRUISE indicator and SET indicator lights will go out. ¼ If you depress the brake pedal while pushing the RES/ACCEL set switch and reset at the cruising speed, turn the main switch off once and then turn it on again. ¼ The cruise control will automatically be cancelled if the vehicle slows down more than 8 MPH (13 km/h) below the set speed. ¼ Depress the clutch pedal (manual transmis- sion), or move the selector lever to N position (automatic transmission). The SET light will go out. To reset at a faster cruising speed, follow either of these three methods: a) Depress the accelerator pedal. When the vehicle attains the desired speed, push and release the COAST/SET switch. b) Push and hold the RES/ACCEL set switch. When the vehicle attains the speed you desire, release the switch. c) Push, then quickly release the RES/ ACCEL set switch. Each time you do this, the set speed will increase by about 1 MPH (1.6 km/h). To reset at a slower cruising speed, follow either of these three methods: a) Lightly tap the brake pedal. When the vehicle attains the desired speed, push the COAST/SET switch and release it. b) Push and hold the COAST/SET switch. Release the switch when the vehicle slows down to the desired speed. c) Push, then quickly release the COAST/ SET switch. Each time you do this, the set speed will decrease by about 1 MPH (1.6 km/h). To resume the preset speed, push and release the RES/ACCEL set switch. The vehicle will resume the last set cruising speed when the vehicle speed is over 25 MPH (40 km/h). Precautions ¼ The CRUISE indicator may sometimes blink when the cruise control switch (Main switch) is turned ON while pushing the RES/ACCEL switch or COAST/SET switch or CANCEL switch (located on the steering wheel). To properly set the cruise control system perform the steps above in the order indicated. (This is a fail-safe mode. Turn the main switch OFF and turn it ON again without pushing the set switch to return to normal operation.) ¼ If the cruise control system malfunctions, it will cancel automatically. The SET indicator in the meter assembly will then blink to warn the driver. ¼ When the SET indicator blinks, turn the cruise control switch (Main switch) OFF and have the system checked by your NISSAN dealer. 5-18 Starting and driving