2006 Nissan Frontier Owner's Manual - Page 205

4WD Shift Switch Position Wheels Driven Indicator Light 4WD shift Transfer 4LO position Use Conditions 4WD Shift Procedure Move the 4WD switch. 2WD 4H 4WD shift indicator light will indicate transfer shift position engaged. Rear wheels 2WD 4 wheels 4H Neutral *1 May blink 4LO 4 wheels Illuminated For driving on dry, paved roads (Economy drive) or state dynamometer I/M testing For driving on rocky, sandy or snowcovered roads Neutral disengages the automatic transmission mechanical parking lock, which will allow the vehicle to roll. Do not leave the transfer shift position in Neutral.*2 For use when maximum power and traction is required (for example: on steep grades or rocky, sandy, muddy roads) 1. Stop the vehicle. 2. For automatic transmission vehicles: Shift the transmission selector to the (N) position with the brake pedal depressed. For manual transmission vehicles: Shift the transmission shift lever to the (N) position with the clutch depressed. 3. For automatic transmission vehicles: Depress and turn the 4WD shift switch to 4LO or 4H with the brake pedal depressed. For manual transmission vehicles: Depress and turn the 4WD switch to 4LO or 4H with the clutch pedal depressed. THE TRANSFER CASE DOES NOT ENGAGE BETWEEN 4H AND 4LO (OR 4LO TO 4H) UNLESS YOU HAVE FIRST STOPPED THE VEHICLE, DEPRESSED THE BRAKE PEDAL AND MOVED THE TRANSMISSION SELECTOR TO NEUTRAL FOR AUTOMATIC TRANSMISSION VEHICLES. FOR MANUAL TRANSMISSION VEHICLES YOU MUST MOVE THE TRANSMISSION SHIFT LEVER TO NEUTRAL. *3 *1: Before moving the transmission selector or shift lever from neutral, wait until the 4LO indicator light stays on steady. This indicates that the 4WD shift procedure is completed and the transfer gear is correctly set in the 4LO position. If the vehicle is shifted into gear before the indicator is on steady, the transfer gear may grind, not engage correctly or stay in the neutral position. - If the 4WD warning light illuminates, perform the following procedure to return the transfer case to correct operating condition. 1. Turn off the engine by turning the ignition switch OFF . 2. Start the engine. - Check that the 4WD warning light turns off. If the 4WD warning light illuminates, have the system checked by a NISSAN dealer. 3. Apply the parking brake, for automatic transmission vehicles, depress the brake pedal and move the transmission selector to Neutral position. For manual transmission vehicles, move the transmission shift lever to Neutral position. 4. With the brake pedal depressed on automatic transmission vehicles or with the clutch pedal depressed on manual transmission vehicles, move the 4WD shift switch to desired mode. - Be sure to wait until the transfer gear change completes before shifting the transmission selector or transmission shift lever from Neutral position. *2: While changing in and out of 4LO, the ignition key must be ON and the vehicle's engine must be running for a shift to take place and for the indicator lights (4WD shift and 4LO position indicator) to be operable. Otherwise, the shift will not take place and no indicator lights will be on or flashing. indicator light (if so equipped) will also turn on when 4LO is selected. See "Vehicle dynamic control *3: Make sure the transfer 4LO position indicator light turns on when you shift the 4WD shift switch to 4LO. The system" later in this section. Starting and driving 5-21