2006 Nissan Sentra Owner's Manual - Page 66

2006 Nissan Sentra Manual

Get 2006 Nissan Sentra PDF manuals and user guides View all 2006 Nissan Sentra manuals

Page 66 highlights

The ambient temperature sensor is located in front of the radiator. The sensor may be affected by road or engine heat, wind directions and other driving conditions. The display may differ from the actual ambient temperature or the temperature displayed on various signs or billboards. NOTE: ● If the amount of fuel added while the ignition switch is OFF is small, the display just before the ignition switch is turned OFF may continue to be displayed. ● When driving uphill or rounding curves, the fuel in the tank shifts, which may momentarily change the display. Journey time The journey time mode shows the time since the last reset. The displayed time can be reset by pressing the change button for more than approximately 1 second. NOTE: If a low temperature warning and low range warning occur simultaneously, other display modes switch automatically to the outside temperature display. Distance to empty (dte-mile or km) The distance to empty (dte) mode provides you with an estimation of the distance that can be driven before refueling. The dte is constantly being calculated, based on the amount of fuel in the fuel tank and the actual fuel consumption. The display is updated every 30 seconds. The dte mode includes a low range warning feature: when the fuel level is low, the dte mode is automatically selected and the digits blink in order to draw the driver's attention. Press the change button if you wish to return to the mode that was selected before the warning occurred. The dte mark (dte) will remain blinking until the vehicle is refueled. When the fuel level drops even lower, the dte display will change to (----). Average fuel consumption (Mpg or l/100km) The average fuel consumption mode shows the average fuel consumption since the last reset. Resetting is done by pressing the change button for more than approximately 1 second. The display is updated every 30 seconds. At about the first 1/3 miles (500 m) after a reset, the display shows (----). Average speed (MPH or km/h) The average speed mode shows the average vehicle speed since last reset. Resetting is done by pressing the change button for more than approximately 1 second. The display is updated every 30 seconds. The first 30 seconds after a reset, the display shows (----). 2-6 Instruments and controls

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
  • 232
  • 233
  • 234
  • 235
  • 236
  • 237
  • 238
  • 239
  • 240
  • 241
  • 242
  • 243
  • 244
  • 245
  • 246
  • 247
  • 248
  • 249
  • 250
  • 251
  • 252
  • 253
  • 254
  • 255
  • 256
The ambient temperature sensor is located in
frontoftheradiator.Thesensormaybeaffected
byroadorengineheat,winddirectionsandother
drivingconditions.Thedisplaymaydifferfromthe
actual ambient temperature or the temperature
displayedonvarioussignsorbillboards.
Distancetoempty(dte—mileorkm)
The distance to empty (dte) mode provides you
with an estimation of the distance that can be
drivenbeforerefueling.Thedteisconstantlybe-
ingcalculated,basedontheamountoffuelinthe
fueltankandtheactualfuelconsumption.
Thedisplayisupdatedevery30seconds.
The dte mode includes a low range warning
feature:whenthefuellevelislow,thedtemodeis
automatically selected and the digits blink in or-
der to draw the driver’s attention. Press the
change button if you wish to return to the mode
that was selected before the warning occurred.
The dte mark (dte) will remain blinking until the
vehicleisrefueled.
When the fuel level drops even lower, the dte
displaywillchangeto(----).
NOTE:
●
If the amount of fuel added while the
ignitionswitchisOFFissmall,thedis-
play just before the ignition switch is
turned OFF may continue to be dis-
played.
●
Whendrivinguphillorroundingcurves,
the fuel in the tank shifts, which may
momentarilychangethedisplay.
Averagefuelconsumption(Mpgor
l/100km)
The average fuel consumption mode shows the
average fuel consumption since the last reset.
Resettingisdonebypressingthechangebutton
for more than approximately 1 second. The dis-
play is updated every 30 seconds. At about the
first 1/3 miles (500 m) after a reset, the display
shows(----).
Averagespeed(MPHorkm/h)
The average speed mode shows the average
vehiclespeedsincelastreset.Resettingisdone
by pressing the change button for more than
approximately 1 second. The display is updated
every 30 seconds. The first 30 seconds after a
reset,thedisplayshows(----).
Journeytime
Thejourneytimemodeshowsthetimesincethe
last reset. The displayed time can be reset by
pressing the change button for more than ap-
proximately1second.
NOTE:
Ifalowtemperaturewarningandlowrange
warning occur simultaneously, other dis-
play modes switch automatically to the
outsidetemperaturedisplay.
2-6
Instrumentsandcontrols