2007 Nissan Armada Owner's Manual - Page 30

To return the 3rd row split bench seat to a seating position unfold the seatback and push it back until it latches into position. WARNING ● When returning the seatbacks, be sure to attach the rear center seat belt connector. ● Do not unfasten the rear center seat belt connector except when folding down the rear seat. ● When attaching the rear center seat belt connector, be certain that the seatbacks are completely secured in the latched position and the rear center seat belt connector is completely secured. ● If the rear center seat belt connector and the seatbacks are not secured in the correct position, serious personal injury may result in an accident or sudden stop. LRS0636 4 LRS0637 The carpet panel flap provides a level cargo floor when the 3rd row seats are also folded flat. Folding the 3rd row split bench seat To fold the 3rd row split bench seat flat for maximum cargo capacity: 1. Disconnect and secure the center seat belt and tongues into the retractor base. See "Stowing the 3rd row center seat belt" later in this section. 2. Lower the head restraints to the full down position. 3. Then pull up on the latch located on the outside corner of each seatback and fold the seatback forward over the seat base. 5. To return the outboard 2nd row bench seats to a seating position reverse the process for the outboard seats. 6. To return the center seat to a seating position, lift up on the pull strap on the back of the seat base while lifting on the seatback. Then push the seat cushion back into place. Make sure to hold the seat belts above the seat cushion and properly raise the seatback to an upright position. Then push the seat cushion down into place. 1-14 Safety-Seats, seat belts and supplemental restraint system