2008 Nissan Titan Owner's Manual - Page 163

tems" section of this manual. For vehicles without navigation system, see your NISSAN dealer. Restarting the entry/exit function If the battery cable is disconnected or if the fuse opens, the entry/exit function will be disabled. Drive the vehicle over 25 MPH (40 km/h) to restart the entry/exit function. You can also restart the entry/exit function using the following procedure. 1. Connect the battery cable or replace the fuse. 2. Open and close the driver's door more than two times with the ignition key in the LOCK position. The entry/exit function should now work properly. ● When the adjusting switch for the driver's seat is turned on while the automatic drive positioner is operating. ● When the memory switch (1 or 2) is not pushed and held for at least 1 second. ● When the seat has been already moved to the memorized position. ● When no seat position is stored in the memory switch. ● When the shift selector lever is moved from P (Park) to any other position. ● When the driver's door remains open more than 45 seconds and the ignition switch is not in the ON position. The automatic drive positioner system can be adjusted and canceled. For vehicles with navigation system, see "Comfort & convenience settings" in the "Display screen, heater, air conditioner and audio systems" section of this manual. For vehicles without navigation system, see your NISSAN dealer. SYSTEM OPERATION The automatic drive positioner system will not work or will stop operating under the following conditions: ● When the vehicle speed is above 4 MPH (7 km/h). ● When any of the memory switches are pushed while the automatic drive positioner is operating. Pre-driving checks and adjustments 3-23