2008 Nissan Xterra Owner's Manual - Page 159

Audio main operation POWER/VOLUME control: Turn the ignition key to ACC or ON, and then press the PWR/VOL control knob while the system is off to call up the mode (radio or CD) which was playing immediately before the system was turned off. To turn the system off, press the PWR/VOL control knob. Turn the PWR/VOL control knob to adjust the volume. This vehicle may be equipped with Speed Sensitive Volume (SSV) for audio. The audio volume changes as the driving speed changes. AUDIO knob (Bass, Treble, Fade and Balance): Press the AUDIO knob to change the mode as follows: Bass → Treble → Fade → Balance To adjust Bass, Treble, Fade and Balance, press the AUDIO knob until the desired mode appears in the display. Turn the Tuning knob to adjust Bass and Treble to the desired level. You can also use the Tuning knob to adjust Fader and Balance modes. Fader adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. Once you have adjusted the sound quality to the desired level, press the AUDIO knob repeatedly until the radio or CD display reappears. Otherwise, the radio or CD display will automatically reappear after about 10 seconds. Clock set 1. Press the DISP/CLOCK button until it beeps (>1.5 seconds). 2. The hours will start flashing. Press the CAT or button or SEEK FOLDER TRACK or button to adjust the hours. 3. Press the DISP/CLOCK button again to switch to the minute adjustment. 4. Press the CAT FOLDER button or SEEK TRACK button to adjust the minutes. or or DISP (display) button: This DISP (display) button will show text about MP3, SAT or CD information in the audio display. CD display mode To change the text displayed while playing a CD with text, press the DISP button. The DISP button will allow you to scroll through CD text as follows: Disc title ←→ Track title. To change the default display mode, press the AUDIO knob repeatedly until DISPLAY MODE appears on the display, then rotate the knob to select the following display modes: Disc number ←→ Folder number. Once the display mode is selected, press the AUDIO knob again to store the setting. If the AUDIO knob is not pressed within 8 seconds, the display will refresh with the last selected display mode setting. ● Track title mode displays the title of the selected CD track. ● Disc title mode displays the title of the CD being played. ● Track number mode displays the number selected disc and the track that is currently being played on the disk. 5. Press the DISP/CLOCK button again to exit the clock set mode. The display will return to the regular clock display after 7 seconds, or you may press the DISP/CLOCK button again to return to the regular clock display. Heater, air conditioner, audio and phone systems 4-21