2009 Nissan Pathfinder Owner's Manual - Page 81
2009 Nissan Pathfinder Manual
Page 81 highlights
Resetting the trip odometer: Pushing the change button for more than 1 second resets the currently displayed trip odometer to zero. change button if you wish to return to the mode that was selected before the warning occurred. The dte mark (dte) will remain blinking until the vehicle is refueled. When the fuel level drops even lower, the dte display will change to (----). NOTE: ● If the amount of fuel added while the ignition switch is OFF is small, the display just before the ignition switch is turned OFF may continue to be displayed. ● When driving uphill or rounding curves, the fuel in the tank shifts, which may momentarily change the display. TRIP COMPUTER (if so equipped) The display of the trip computer is situated in the speedometer display. When the ignition switch is placed in the ON position, the display scrolls all the modes of the trip computer and then shows the mode chosen before the ignition switch was placed in the OFF position. LIC0781 With trip computer For vehicles equipped with trip computer, pushing the change button changes the display as follows: Trip → Trip → Distance to Empty → Average speed → Average fuel consumption → Journey time → Trip For additional information, refer to "Trip computer" later in this section. For vehicles equipped with navigation system, refer to "How to use the INFO button" in the "Display screen, heater, air conditioner and audio systems" section later in this manual. When the ignition switch is placed in the ON position, modes of the trip computer can be selected by pushing the trip computer change button. The following modes can be selected: Distance to empty (dte-mile or km) The distance to empty (dte) mode provides you with an estimation of the distance that can be driven before refueling. The dte is constantly being calculated, based on the amount of fuel in the fuel tank and the actual fuel consumption. The display is updated every 30 seconds. The dte mode includes a low range warning feature: when the fuel level is low, the dte mode is automatically selected and the digits blink in order to draw the driver's attention. Press the Average speed (MPH or km/h) The average speed mode shows the average vehicle speed since last reset. Resetting is done by pressing the change button for more than approximately 1 second. The display is updated every 30 seconds. The first 30 seconds after a reset, the display shows (----). Average fuel consumption (Mpg or l/100km) The average fuel consumption mode shows the average fuel consumption since the last reset. Instruments and controls 2-5