2009 Nissan Titan King Cab Owner's Manual - Page 138

PROGRAMMING HOMELINKா FOR CANADIAN CUSTOMERS Prior to 1992, D.O.C. regulations required handheld transmitters to stop transmitting after 2 seconds. To program your hand-held transmitter to HomeLinkா, continue to press and hold the HomeLinkா button (see steps 2 - 4 under "Programming HomeLinkா") while you press and repress ("cycle") your hand-held transmitters every 2 seconds until the indicator light flashes rapidly (indicating successful programming). NOTE: When programming a garage door opener, etc., it is advised to unplug the device during the "cycling" process to prevent possible damage to the garage door opener components. PROGRAMMING TROUBLEDIAGNOSIS If the HomeLinkா does not quickly learn the handheld transmitter information: ● replace the hand-held transmitter batteries with new batteries. ● position the hand-held transmitter with its battery area facing away from the HomeLinkா surface. ● press and hold both the HomeLinkா and hand-held transmitter buttons without interruption. ● position the hand-held transmitter 1 3 inches (26 - 76 mm) away from the HomeLinkா surface. Hold the transmitter in that position for up to 15 seconds. If HomeLinkா is not programmed within that time, try holding the transmitter in another position - keeping the indicator light in view at all times. If you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. The phone numbers are located in the Foreword of this manual. CLEARING THE PROGRAMMED INFORMATION Individual buttons cannot be cleared. However, to clear all programming, press and hold the two outside buttons and release when the indicator light begins to flash (approximately 20 seconds). REPROGRAMMING A SINGLE HOMELINKா BUTTON To reprogram a HomeLinkா Universal Transceiver button, complete the following. 1. Press and hold the desired HomeLinkா button. Do not release the button until step 4 has been completed. 2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 1 - 3 inches (26 76 mm) away from the HomeLinkா surface. 3. Press and hold the hand-held transmitter button. 4. The HomeLinkா indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons. OPERATING THE HOMELINKா UNIVERSAL TRANSCEIVER The HomeLinkா Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply press the appropriate programmed HomeLinkா Universal Transceiver button. The amber indicator light will illuminate while the signal is being transmitted. 2-60 Instruments and controls