2009 Nissan Xterra Owner's Manual - Page 179
2009 Nissan Xterra Manual
Page 179 highlights
BLUETOOTH is a trademark owned by Bluetooth SIG, Inc., U.S.A. and licensed to Visteon. Operating tips To get the best performance out of the NISSAN Voice Recognition system, observe the following: ● Keep the interior of the vehicle as quiet as possible. Close the windows to eliminate surrounding noises (traffic noises, vibration sounds, etc.), which may prevent the system from recognizing voice commands correctly. ● Wait until the tone sounds before speaking a command. Otherwise, the command will not be received properly. ● Start speaking a command within 5 seconds after the tone sounds. ● Speak in a natural voice without pausing between words. ● If a command is not recognized, the system announces, "Command not recognized. Please try again." Repeat the command in a clear voice. ● If you want to go back to the previous command, you can say "Go back" or "Correction" any time the system is waiting for a response. ● You can cancel a command when the system is waiting for a response by saying, "Cancel" or "Quit." The system announces "Cancel" and ends the VR session. You can button on the steering also press the wheel at any time. Whenever the VR session is cancelled, a double beep is played to indicate you have exited the system. ● If you want to adjust the volume of the voice feedback, press the volume control switches (+ or -) on the steering wheel while being provided with feedback. You can also use the radio volume control knob. ● In most cases you can interrupt the voice feedback to speak the next command by pressing the button on the steering wheel. USING THE SYSTEM The NISSAN Voice Recognition system allows hands-free operation of the Bluetooth Phone System. If the vehicle is in motion, some commands may not be available so full attention may be given to vehicle operation. Initialization When the ignition switch is placed in the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. When completed, the amber light on the overhead console illuminates and the system is ready to accept voice commands. If the button is pressed before the initialization completes, the system will announce "Hands-free phone system not ready" and will not react to voice commands. Giving voice commands To operate NISSAN Voice Recognition, press button located on the and release the steering wheel. After the tone sounds, speak a command. The command given is picked up by the microphone, and voice feedback is given when the command is accepted. ● If you need to hear the available commands for the current menu again, say "Help" and the system will repeat them. Heater, air conditioner, audio and phone systems 4-41