2012 Nissan Murano Owner's Manual - Page 356
2012 Nissan Murano Manual
Page 356 highlights
R (Reverse): GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Use this position to back up. Make sure the vehicle is completely stopped before selecting the R (Reverse) position. The brake pedal must be depressed and the selector lever button pushed in to move the selector lever from P (Park), N (Neutral) or any driving position to R (Reverse). N (Neutral): GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Neither forward nor reverse gear is engaged. The engine can be started in this position. You may shift to N (Neutral) and restart a stalled engine while the vehicle is moving. D (Drive): GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Use this position for all normal forward driving. L (Low): GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Use this position for maximum engine braking on steep downhill gradients/climbing steep slopes and whenever approaching sharp bends. Do not use the L position in any other circumstances. Accelerator GUID-CD19E66D-4772-4785-B00D-BC9BC6AC4E04 downshift - In D position - For passing or hill climbing, fully depress the accelerator pedal to the floor. This shifts the transmission down into a lower gear, depending on the vehicle speed. High fluid temperature protection mode GUID-FE0DB0A0-F4AF-44F6-8609-E1599FEA814D This transmission has a high fluid temperature protection mode. If the fluid temperature becomes too high (for example, when climbing steep grades in high temperature with heavy loads, such as when towing a trailer), engine power and, under some conditions, vehicle speed will be decreased automatically to reduce the chance of transmission damage. Vehicle speed can be controlled with the accelerator pedal, but the engine and vehicle speed may be limited. SSD0692 Overdrive (O/D) OFF switch GUID-8A3D61C2-25AC-4088-A419-A1EAB3D4657F When the O/D OFF switch is pushed with the selector lever in the D (Drive) position, the indicator light in the instrument panel illuminates. Use the overdrive off mode when you need improved engine braking. To turn off the overdrive off mode, push the O/D OFF switch again. The indicator light will turn off. Each time the engine is started, or when the selector lever is shifted to any position other than the D (Drive) position, the overdrive off mode will be automatically turned off. Fail-safe GUID-CA9C7C97-9363-4621-960F-9DED536408A1 If the vehicle is driven under extreme conditions, such as excessive wheel spinning and subsequent hard braking, the fail-safe system may be activated. The MIL may illuminate to indicate the fail-safe mode is activated. (See "Malfunction Indicator Light (MIL)" in the "2. Instruments and controls" section.) This will occur even if all electrical circuits are functioning properly. In this case, place the ignition 5-16 Starting and driving