2014 Nissan Quest Navigation System Owner's Manual - Page 80
2014 Nissan Quest Manual
Page 80 highlights
2. After the tone sounds, speak a command. To set the previous start point as the destination: "Previous Start Point" (Alternate command mode) 3. Highlight [Stored Routes] and push . A list screen is displayed. INFO: . Even after setting a destination, the location of the destination can be adjusted, the location can be stored, etc. "Procedures after setting destination" (page 5-2) The stored route includes only locations (destination and waypoints) and route calculation conditions, not the route itself. Therefore, when the destination is set using a stored route, a different route may be suggested if the current vehicle location is different from the one when the route was stored. SETTING FROM STORED ROUTES A preferred route can be selected from the stored routes. . 4. Highlight the preferred route from the list and push . The route to the destination is set. SETTING BY PHONE NUMBER 1. Push . 2. Highlight [Next Page] and push . If the telephone number of the facility is available, use this to find the facility by entering the number, and then have the system calculate a route. 5. The entire route is shown on the map. Highlight [Start] after confirming the location of the displayed destination, and push . The system sets the destination to the selected location and starts calculating a route. INFO: . . Telephone numbers that were stored for stored destinations can also be used. If the area code of the specified telephone number does not exist in the map data, the system will not search for the location. 4-14 Setting destination