2000 Polaris Universal ATV Owners Manual - Page 65

VEHICLE BREAK-IN PERIOD 4-Cycle Engines The break in period for your new Polaris ATV is defined as the first ten hours of operation, or the time it takes to use the first two tanks full of gasoline. No single action on your part is as important as a proper break in period. Careful treatment of a new engine will result in more efficient performance and longer life for the engine. Perform the following procedures carefully. CAUTION: Use only Polaris Premium 4 All Season synthetic oil, or API certified "SH" oil. Never substitute or mix oil brands. Serious engine damage and voiding of warranty can result. 1.Fill fuel tank with either unleaded or leaded fuel which has a minimum pump octane number of 87= (R+ M)/2. 2.Check oil reservoir level indicated on dipstick. Add oil if necessary. 3.Drive slowly at first. Select an area which is open and will give you room to familiarize yourself with vehicle operation and handling. ADD 8 OZ. NORMAL FULL Maintain Oil Level In Normal Range 4.Vary the throttle positions. Do not operate at sustained idle. CAUTION: Do not operate at full throttle or high speeds for extended periods during the first three hours of use. Excessive heat can build up and cause damage to close fitted engine parts. 5.Perform regular checks on fluid levels, controls and all important areas on the vehicle as outlined earlier on the daily pre-ride inspection checklist found on page 14. 6.Pull only light loads. 7.Break in oil and filter. Change at 20 hours or 500 miles. 57