2006 Polaris Sportsman 700 EFI Owners Manual - Page 48
2006 Polaris Sportsman 700 EFI Manual
Page 48 highlights
Instrument Cluster FEATURES AND CONTROLS Rider Information Center Special EFI Diagnostic Mode The EFI diagnostic mode is for informational purposes only. Please see your Polaris dealer for all major repairs. To download blink codes (failure codes) from the EFI module: 1. Place the transmission in PARK, turn the engine off and turn the key switch to the ON position. 2. Turn the key switch off and on three times in less than five seconds, then leave the switch on. Any blink code numbers stored in the EFI module will display, one at a time, in the alphanumeric display. The number "61" and the word "END" will display after all codes have been transmitted. Blink Code 21 45 46 22 22 23 42 42 51 51 51 52 52 52 Failure Description No RPM Signal Loss of Synchronization Barometric Pressure Sensor: Circuit Low Input Barometric Pressure Sensor: Circuit High Input TPS: Open or Short Circuit to Ground TPS: Short Circuit to Battery RAM Error: Defective ECU Engine Temp Sensor Circuit: Short to Ground Engine Temp Sensor Circuit: Open or Short to Battery Injector 1: Open Load Injector 1: Short Circuit to Ground Injector 1: Short Circuit to Battery Injector 2: Open Load Injector 2: Short Circuit to Ground Injector 2: Short Circuit to Battery Blink Code 54 54 54 55 55 55 56 56 56 41 41 61 Failure Description Engine Temp Lamp: Open Load Engine Temp Lamp: Short Circuit to Ground Engine Temp Lamp: Short Circuit to Battery Diag Lamp: Open Load Diag Lamp: Short Circuit to Ground Diag Lamp: Short Circuit to Battery Pump Relay: Open Load Pump Relay: Short Circuit to Ground Pump Relay: Short Circuit to Battery Intake Air Temp Sensor: Open or Short Circuit to +Sensor Voltage Intake Air Temp Sensor: Short Circuit to Ground END 45