2009 Polaris Ranger Crew Owners Manual - Page 29
2009 Polaris Ranger Crew Manual
Page 29 highlights
FEATURES AND CONTROLS Instrument Cluster Rider Information Center The rider information center is located in the instrument cluster. All segments will light up for 2.5 seconds at start-up. NOTE: If the instrument cluster fails to illuminate, a battery over-voltage may have occurred and the instrument cluster may have shut off to protect the electronic speedometer. If this occurs, take the vehicle to your Polaris dealer for proper diagnosis. 1. Gear Indicator - This 6 3 4 5 7 indicator displays gear shifter position. 8 H = High Gear L = Low Gear N = Neutral R = Reverse Gear 2 2. AWD Indicator - This indicator illuminates when the AWD switch is in the AWD posi1 tion. 3. Engine Hour Display Indicator 4. Service Interval/Diagnostic Mode Indicator 5. Low Battery and Over Voltage - This warning usually indicates that the vehicle is operating at an RPM too low to keep the battery charged. It may also occur when the engine is at idle and high electrical load (lights, cooling fan, accessories) is applied. Drive at a higher RPM or recharge the battery to clear the warning. 6. Odometer/Tachometer/Tripmeter/ Hour Meter/Clock 7. Fuel Gauge - The segments of the fuel gauge show the level of fuel in the fuel tank. When the last segment clears, a low fuel warning is activated. All segments will flash, FUEL will display in the LCD, and the speedometer needle will blink. Refuel immediately. 8. Check Engine Warning Indicator - This indicator serves two purposes. The word HOT displays if the engine overheats. It also appears if an EFI-related fault occurs. Do not operate the vehicle if this warning appears. Serious engine damage could result. 26