2011 Polaris Hammer 8-Ball Owners Manual - Page 23
2011 Polaris Hammer 8-Ball Manual
Page 23 highlights
Instruments, Features and Controls Instrument Cluster Speedometer The speedometer displays vehicle speed in either miles per hour (MPH) or kilometers per hour (km/h). Speedometer Indicator Lamps Multi-Function Display Indicator Lamps Lamp Indicates Neutral High Beam Turn Signal Condition This lamp illuminates when the transmission is in neutral and the ignition key is in the ON position. This lamp illuminates when the headlamp switch is set to high beam. The turn signal indicator flashes when the left, right, or both turn signals (hazard) are active. If a bulb fails, or if there is a short circuit in the signal system, the lamp flashes at more than twice the normal rate. This lamp illuminates when the ignition switch is in the ON position and the engine is off, indicating that the indicator circuit is functioning properly. This lamp also illuminates if engine oil pressure drops below safe operating pressure. If this lamp illuminates while the engine is running, turn the engine off as soon as safely possible and check the oil level. If the oil level is correct and the lamp remains on after the engine is restarted, turn the engine off immediately. This lamp illuminates when approximately one gallon (3.8 liters) of fuel remains in the fuel tank. This lamp illuminates momentarily when the ignition switch is in the ON position and the engine is off. This indicates proper function. If this lamp illuminates while the engine is running, contact an authorized VICTORY dealer promptly for diagnosis. The light will remain on if the tilt sensor shuts down the engine. See page 37. If abnormal sensor or engine operation is detected the light will remain on as long as the fault condition exists. Retrieve the error codes for diagnosis. See page 22. This lamp is also known as a malfunction indicator lamp (MIL). Low Oil Pressure Low Fuel Check Engine Cruise Control Engaged (if equipped) 19