2011 Polaris Sportsman XP 850 Owners Manual - Page 102
2011 Polaris Sportsman XP 850 Manual
Page 102 highlights
MAINTENANCE Lights High Beam Adjustment The headlight beam can be adjusted slightly upward or downward. Use the following procedure to make the adjustment. 1. Position the vehicle on a level surface with the headlight approximately 25 ft. (7.6 m) from a wall. Place the transmission in PARK. 25 ft. (7.6 m) Lamp Center Height 2" (5 cm) 2. Measure the distance from the floor to the center of the headlight and make a mark on the wall at the same height. 3. Start the engine. Turn the headlight switch to high beam. 4. Observe the headlight aim on the wall. The most intense part of the headlight beam should be two inches (5 cm) below the mark on the wall. Include rider weight on the seat when measuring. 5. The adjustment screw is Adjustment located on the right side of Screw the headlight pod. To adjust the beam, loosen the screw. Adjust the headlamp to the desired position, then tighten the screw. 98