2013 Polaris Ness Signature Series Vision Tour Owners Manual - Page 25
2013 Polaris Ness Signature Series Vision Tour Manual
Page 25 highlights
Instruments, Features and Controls Indicator Lamps High Beam Left Turn Anti-Lock Brake System (ABS) (if equipped) Low Fuel Right Turn Cruise Control Oil Pressure Check Engine Neutral Battery Warning Lamp Indicates Neutral High Beam Check Engine Condition This lamp illuminates when the transmission is in neutral and the ignition key is in the ON or ACC position. This lamp illuminates when the headlamp switch is set to high beam. This lamp illuminates momentarily when the ignition switch is in the ON position and the engine is off. This indicates proper function. This lamp will illuminate if the engine is disabled by the sidestand interlock switch. See page 36. The light will also remain on if the tilt sensor shuts down the engine. See page 28. If this lamp illuminates while the engine is running, contact an authorized VICTORY dealer promptly for diagnosis. If abnormal sensor or engine operation is detected the light will remain on as long as the fault condition exists. Retrieve the error codes for diagnosis. See page 25. This lamp is also known as a malfunction indicator lamp (MIL). One arrow flashes when the corresponding turn signal is activated. Both arrows flash when the hazard signal is activated. If a bulb fails, or if there is a short circuit in the signal system, the lamp flashes at more than twice the normal rate. This lamp illuminates when the ignition switch is in the ON position and the engine is off, indicating that the indicator circuit is functioning properly. This lamp also illuminates if engine oil pressure drops below safe operating pressure. If this lamp illuminates while the engine is running, turn the engine off as soon as safely possible and check the oil level. If the oil level is correct and the lamp remains on after the engine is restarted, turn the engine off immediately. Turn Signal Low Oil Pressure 23