2002 Saab 9-5 Owner's Manual - Page 59
2002 Saab 9-5 Manual
Page 59 highlights
Instruments and controls 1 This message cannot be removed by pressing CLEAR. Depress the brake pedal. 2 This message will be displayed approximately 600 miles (1,000 km) before the next scheduled service is due, or when 365 days have elapsed since the last service. The message should be cleared at the time of that service (see the Saab Warranties & Service Record Booklet). If you have carried out the service yourself, you can clear the message by pressing CLEAR once. Reset by pressing CLEAR for at least eight seconds, until "SERVICE" appears on the display and a chime sounds. 59 Night panel To improve night-driving conditions inside the car, the Night Panel mode can be selected. In this mode, the amount of information displayed is reduced, and only the most important instruments and displays will be illuminated. When the Night Panel button is pressed, only the speedometer will be illuminated (up to the 87-mph or 140-km/h graduation), all the other instruments illumination being extinguished and their needles moved to zero. Both the SID and the ACC displays will be extinguished and the backlighting for switches and other controls will be dimmed. Note: All indicator and warning lights, together with the display of CHECK messages, will operate as normal, except "Frost warning", see page 55. The following conditions will wake up the respective displays in the Night-Panel mode: • Setting of the Audio system, SID or ACC (display comes on for ten seconds). • CHECK message generated in the SID. • High engine revs cause the rev counter to be illuminated until the engine speed has fallen again. • If the quantity of fuel remaining falls below 4 gallons (15 liters), the fuel gauge will be illuminated. • If the engine temperature rises above normal, the temperature gauge will be illuminated. • If the speed of the car exceeds 84 mph (135 km/h), the entire speedometer will be illuminated. • In cars with automatic transmission, if the selector lever is moved from D to position 3, 2 or 1, the selector indication on the main instrument panel will be illuminated. To restore the displays and lighting to the normal mode, press the Night-Panel button.