2000 Subaru Legacy Owner's Manual - Page 134
2000 Subaru Legacy Manual
Page 134 highlights
Instruments and controls the proper level but the light remains on, contact your nearest SUBARU dealer immediately. J AT OIL TEMPerature warning light (for AT vehicles) If this light comes on when the engine is running, it may indicate that the automatic transmission fluid temperature is too hot. If the light comes on while driving, it is unnecessary to stop the vehicle, but avoid driving up steep grades or in stop and go traffic. B Automatic transmission control system warning If the light flashes after the engine starts, it may indicate that the automatic transmission control system is not working properly. Contact your nearest SUBARU dealer for service immediately. J ABS warning light (U.S.) (Canada) The ABS warning light comes on when the ignition switch is turned to the "ON" position and goes out after about two seconds. This is an indication that the ABS system is working properly. If the warning light behaves as follows, the ABS system may not work properly. D The warning light does not come on when the ignition switch is turned to the "ON" position. D The warning light comes on when the ignition switch is turned to the "ON" position, but it does not go out even when the vehicle speed exceeds approximately 8 mph (12 km/h). D The warning light comes on during driving. When the warning light is on, the ABS function shuts down; however, the conventional brake system continues to operate normally. If this occurs, have the ABS system repaired at the first available opportunity by your SUBARU dealer. - CONTINUED - 3-13