2004 Subaru Forester Owner's Manual - Page 195
2004 Subaru Forester Manual
Page 195 highlights
Audio FM/AM/Weather band selection button (BAND) Push the "BAND" button when the radio is on to select FM1, FM2, AM or Weather band (WB) reception. Each time this button is pressed, the band will change in the following order: ing button (3) marked " " to change the WB channel up and press the tuning button marked " " to change the WB channel down. Each time the button is pressed, the WB channel changes to the next channel. Seek tuning If the tuning button (3) is pressed for longer than half of a second, the radio will begin to automatically search for receivable frequencies and will stop at the first one found. This function may not be available, however, when radio signals are weak. In such a situation, perform manual tuning to select the desired station. Automatic tuning (SCAN) Press the "SCAN" button (6) to change the radio to the SCAN mode. In this mode, the radio scans through the radio band until a station is found. The radio will stop at the station for five seconds while displaying the frequency, after which scanning will continue until the entire band has been scanned from the low end to the high end. Press the "SCAN" button again to cancel the SCAN mode and to stop on any displayed frequency. When the "SCAN" button is pressed for automatic tuning, stations are scanned in the direction of low frequencies to high frequencies only. FM1 FM2 WB AM The display indicates which one is currently selected. Stereo indicator The stereo indicator "ST" will come on when an FM stereo broadcast is received. Tuning (TUNE) Manual tuning (TUNE) Push the tuning button (3) marked " " to increase the tuning frequency and press the tuning button marked " " to decrease it. Each time the button is pressed, the frequency changes 10 KHz in the AM waveband and 0.2 MHz in the FM waveband. Manual tuning for weather band When weather band mode is selected, press the tun5-8