2007 Subaru Legacy Owner's Manual - Page 231

6-20 Interior equipment may make the programming quicker and easier. trol System and your garage door opener should activate when the HomeLink® button is pressed. & Programming for entrance gates and garage door openers in Canada 1. Unplug the motor of the entrance gate or garage door opener from the outlet. 1) Training button 1. Locate the training button on the garage door opener motor head unit. The exact location and color of the button may vary by brand of garage door opener. If it is difficult to locate the training button, refer to your garage door opener's instruction manual. 2. Press the training button on the garage door opener motor head unit (which activates the "training light" on the unit). Proceed to step 3 within 30 seconds. 3. Inside the vehicle, firmly press and release the HomeLink® button that was programmed in the section above. Press and release the button a second time to complete the programming procedure. NOTE Some garage door openers may require you to do the above procedure a third time to complete the programming. 4. The garage door opener should now recognize the HomeLink® Wireless Con- 2. Press and hold the two outside buttons until the HomeLink® indicator light begins to flash (after 20 seconds). Release both buttons. NOTE If any of the HomeLink® buttons are already programmed for other devices, skip step 2 because it clears the