2009 Subaru Impreza Owner's Manual - Page 122

Instruments and controls 3-7 nation after the driver's door is opened, the illumination will be turned off. . Even during the gradual turning off after the ignition switch is turned to the "LOCK" position, if the ignition switch is turned to the "ON" position, the combination meter illuminate as usual. To change the setting: 1. Turn the ignition switch to the "LOCK" or "Acc" position or " ", and " " or " " cannot be displayed when the ignition switch is in the "ON" position. 3. To change the current setting, press the trip knob for at least 2 seconds. : Activated : Deactivated & Odometer/Trip meter 1) Trip knob This meter displays the odometer and two trip meters when the ignition switch is in the "LOCK", "Acc" or "ON" position. If you press the trip knob when the ignition switch is in the "LOCK" position, the odometer/trip meter will light up. It is possible to switch the indications while the odometer/trip meter is lit up. If you do not press the trip knob within 10 seconds of illumination of the odometer/trip meter, the odometer/trip meter will turn off. The display can be switched as shown below by pressing the trip knob. NOTE 2. Press the trip knob to show " " or " on the odometer and trip meter " display. The display can be switched as shown in the following illustration by pressing the trip knob. The initial illumination setting of the meter/gauge needles of your vehicle " at the has been set for activation " time of shipment from the factory. & Speedometer The speedometer shows the vehicle speed. - CONTINUED -