2010 Subaru Impreza Owner's Manual - Page 361

11-42 Maintenance and service & Windshield wiper blade assembly ! Type A 1. Raise the wiper arm off the windshield. ! Type B 1. Raise the wiper arm off the windshield. & Windshield wiper blade rubber (type A and type B) NOTE The following illustrations show the replacement procedures of the blade rubber for a type A wiper blade assembly, however the replacement procedures are the same for a type B wiper blade assembly. 1) 2) 1) Stopper Open the cover Pull down the wiper blade 2. Remove the wiper blade assembly by holding its pivot area and pushing it in the direction shown by the arrow while depressing the wiper blade stopper. 3. Install the wiper blade assembly to the wiper arm. Make sure that it locks in place. 4. Hold the wiper arm by hand and slowly lower it in position. 2. Remove the wiper blade assembly by opening the cover and pulling it down in the direction shown in the illustration. 3. Install the wiper blade assembly to the wiper arm. Make sure that it locks in place. 4. Hold the wiper arm by hand and slowly lower it in position. 1) Metal support 1. Grasp the locked end of the blade rubber assembly and pull it firmly until the stoppers on the rubber are free of the metal support.