2012 Subaru Forester Owner's Manual - Page 467

Maintenance and service 11-45 corresponding fuse. If a fuse has blown, replace it. 1. Turn the ignition switch to the "LOCK" position and turn off all electrical accessories. 2. Remove the cover. 3. Determine which fuse may be blown. Look at the back side of each fuse box cover and refer to "Fuses and circuits" F12-11. Installation of accessories Always consult your SUBARU dealer before installing fog lights or any other electrical equipment in your vehicle. Such accessories may cause the electronic system to malfunction if they are incorrectly installed or if they are not suited for the vehicle. Replacing bulbs WARNING Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down. Otherwise, there is a risk of burn injury. CAUTION Replace any bulb only with a new bulb of the specified wattage. Using a bulb of different wattage could result in a fire. For the specified wattage of each bulb, refer to "Bulb chart" F12-15. & Headlights (models with HID headlights) 4. Pull out the fuse with the fuse puller. 5. Inspect the fuse. If it has blown, replace it with a spare fuse of the same rating. 6. If the same fuse blows again, this indicates that its system has a problem. Contact your SUBARU dealer for repairs. WARNING High-intensity-discharge (HID) bulbs are used for the low beams of the headlights. These HID bulbs use an extremely high voltage. To avoid the risk of an electric shock that could result in serious injury, observe the - CONTINUED -