2006 Suzuki Forenza Owner's Manual - Page 209

SERVICE AND APPEARANCE CARE Tail/Stop Lamps, Turn Signal Lamps and Backup Lamps (Sedan) Tail/Stop Lamps, Turn Signal Lamps and Backup Lamps (Wagon) 7) Replace the lamp housing into the vehicle using the two screws removed earlier. 8) Close the liftgate. License Plate Lamps N5U5004A To replace a tail/stop lamp bulb, a rear turn signal lamp bulb, or a rear backup lamp bulb: 1) Open the trunk. 2) Open the trim cover. 3) Remove the bulb socket by turning it counterclockwise. 4) Remove the bulb from the socket by pressing the bulb and turning it counterclockwise. 5) Install the appropriate bulb into the socket. See "Replacement Bulbs" in this section. 6) Replace the bulb socket into the lamp housing. Turn the bulb socket clockwise to secure it. 7) Replace the trim cover. 8) Close the trunk. To replace a tail/stop lamp bulb, a rear turn signal lamp bulb, or a rear backup lamp bulb: 1) Open the liftgate. 2) Remove the two screws shown in the illustration and the lamp assembly. 3) Remove the bulb socket from the lamp housing by turning the bulb socket counterclockwise. 4) Remove the bulb from the socket by pressing the bulb and turning it counterclockwise. 5) Install the appropriate bulb into the socket. See "Replacement Bulbs" in this section. 6) Replace the bulb socket into the lamp housing. N4U5029B To replace a license plate lamp bulb: 1) Remove the two screws shown in the illustration and the lamp cover. 2) To remove the bulb holder from the lamp housing, rotate the bulb holder counterclockwise. 3) Pull the bulb out from the bulb holder. 4) Replace the bulb. See "Replacement Bulbs" in this section for the proper bulb. 5) Install the bulb holder into the lamp housing by rotating the bulb holder clockwise. 6) Replace the lamp cover. 5-26