1997 Toyota Corolla Owners Manual - Page 64
1997 Toyota Corolla Manual
Page 64 highlights
Tilt steering wheel Without filler panel trim- a. Remove the cap on the filler panel you wish to use. b. Insert a 10 mm (0.4 in.) spacer and tighten down the anchor bracket for your child restraint system with a bolt. Torque the bolt to 16.5-24.7 N⋅m (1.68-2.52 kgf⋅m, 12.2-18.2 ft⋅lbf). To comply with Canada Motor Vehicle Safety Standards, vehicles sold in Canada are provided with a bracket set in the glovebox, designed for use with any of the 3 anchor locations shown in the illustration. If your child restraint system does not provide any of the necessary parts, ask your Toyota dealer. (See "-Child restraint system".) On the filler panel behind the rear seat With filler panel trim- a. Using the illustration as a guide, run your fingers across trim of the filler panelitself to locate the position of the holes underneath. b. Make a hole in the covering directly above the hole in the filler panel. c. Insert a 10 mm (0.4 in.) spacer and tighten down the anchor bracket for your child restraint system with a bolt. Torque the bolt to 16.5−24.7 N⋅m (1.68−2.52 kgr⋅m, 12.2−18.2 ft⋅lf). To change the steering wheel angle, pull up the lock release lever, tilt the steering wheel to the desired angle and release the lever. ! CAUTION S Do not adjust the steering wheel while the vehicle is moving. S After adjusting the steering wheel, try moving it up and down to make sure it is locked in position. 62