2010 Toyota Camry Warranty, Maitenance, Services Guide - Page 72

Explanation of Maintenance Items Engine Oil and Oil Filter Replace the oil filter and drain and refill the engine oil at specified intervals. For recommended oil grade and viscosity, refer to the Owner's Manual. NOTE: Your vehicle may be factory filled and certified with Genuine Toyota 0W20 motor oil. Refer to the maintenance log (Schedule A and B) to determine which maintenance schedule is applicable for your vehicle (based on engine AND OIL type). For VEHICLES CERTIFIED FOR 0W20 motor oil, the oil change interval is 10,000 miles or 12 months IF 0W20 MOTOR OIL IS BEING USED. If 0W20 is not available, 5W20 mineral oil may be used. However, it must be replaced at A 5,000 miles or 6 month INTERVAL with 0W20 motor oil. For VEHICLES NOT CERTIFIED FOR 0W20 motor oil, the oil change interval does not change. It remains 5,000 miles or 6 months, REGARDLESS OF WHETHER 0W20 MOTOR OIL IS BEING USED. For customers who primarily drive their vehicle under any of the listed Special Operating Conditions, the motor oil and filter should be replaced at 5,000 miles or 6 months, REGARDLESS OF THE OIL USED (OR CERTIFICATION OF THE VEHICLE). Engine Valve Clearance Inspect for tappet noise and engine vibration and adjust if necessary. A qualified technician should perform this operation. Exhaust Pipes and Mountings Visually inspect the exhaust pipes, muffler and hangers for cracks, deterioration and damage. Start the engine and listen carefully for any exhaust gas leakage. Tighten connections or replace parts as necessary. MAINTENANCE Fuel Lines and Connections, Fuel Tank Band and Fuel Tank Vapor Vent System Hoses Visually inspect for corrosion, damage, cracks, and loose or leaking connections. Tighten connections or replace parts as necessary. Fuel Tank Cap Gasket Visually inspect for cracks, deterioration and damage and replace if necessary. Nuts and Bolts on Chassis and Body Re-tighten the seat-mounting bolts and front/rear suspension member retaining bolts to specified torque. Radiator and Condenser Inspect for debris, corrosion and signs of damage. Have any problem repaired immediately by a qualified technician. 70 Maintenance Log