2003 Yamaha Motorsports VMAX Owners Manual - Page 23

2003 Yamaha Motorsports VMAX Manual

Get 2003 Yamaha Motorsports VMAX PDF manuals and user guides View all 2003 Yamaha Motorsports VMAX manuals

Page 23 highlights

INSTRUMENT AND CONTROL FUNCTIONS EAU04166 EAU04167 Fuel level warning light "FUEL" This warning light comes on when the fuel level drops below approximately 3 L (0.7 Imp gal, 0.8 US gal). When this occurs, set the fuel reserve switch to the "RES" position and refuel as soon as possible. The electrical circuit of the warning light can be checked according to the following procedure. 1. Set the engine stop switch to "RUN" and turn the key to "ON". 2. Shift the transmission into the neutral position or pull the clutch lever. 3. Push the start switch. If the warning light does not come on, have a Yamaha dealer check the electrical circuit. EAU00064 Oil level warning light "OIL LEVEL" This warning light comes on when the engine oil level is low. The electrical circuit of the warning light can be checked according to the following procedure. 1. Set the engine stop switch to "RUN" and turn the key to "ON". 2. Shift the transmission into the neutral position or pull the clutch lever. 3. Push the start switch. If the warning light does not come on, have a Yamaha dealer check the electrical circuit. NOTE: Even if the oil level is sufficient, the warning light may flicker when riding on a slope or during sudden acceleration or deceleration, but this is not a malfunction. _ 3 1. Tripmeter reset knob 2. Odometer 3. Tripmeter EAU00095 Speedometer unit The speedometer unit is equipped with a speedometer, an odometer and a tripmeter. The speedometer shows riding speed. The odometer shows the total distance traveled. The tripmeter shows the distance traveled since it was last set to zero with the reset knob. The tripmeter can be used to estimate the distance that can be traveled with a full tank of fuel. This information will enable you to plan future fuel stops. High beam indicator light "HIGH BEAM" This indicator light comes on when the high beam of the headlight is switched on. 3-2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
INSTRUMENT AND CONTROL FUNCTIONS
3-2
3
EAU04166
Fuel level warning light “FUEL”
This warning light comes on when the
fuel level drops below approximately
3 L (0.7 Imp gal, 0.8 US gal). When this
occurs, set the fuel reserve switch to
the “RES” position and refuel as soon
as possible.
The electrical circuit of the warning light
can be checked according to the fol-
lowing procedure.
1. Set the engine stop switch to
“RUN” and turn the key to “ON”.
2.
Shift the transmission into the neu-
tral position or pull the clutch lever.
3.
Push the start switch. If the warn-
ing light does not come on, have a
Yamaha dealer check the electri-
cal circuit.
EAU00064
High beam indicator light
“HIGH BEAM”
This indicator light comes on when the
high beam of the headlight is switched
on.
EAU04167
Oil level warning light “OIL LEVEL”
This warning light comes on when the
engine oil level is low.
The electrical circuit of the warning light
can be checked according to the fol-
lowing procedure.
1. Set the engine stop switch to
“RUN” and turn the key to “ON”.
2.
Shift the transmission into the neu-
tral position or pull the clutch lever.
3.
Push the start switch. If the warn-
ing light does not come on, have a
Yamaha dealer check the electri-
cal circuit.
NOTE:
Even if the oil level is sufficient, the
warning light may flicker when riding on
a slope or during sudden acceleration
or deceleration, but this is not a mal-
function.
_
EAU00095
Speedometer unit
The speedometer unit is equipped with
a speedometer, an odometer and a
tripmeter. The speedometer shows
riding speed. The odometer shows the
total distance traveled. The tripmeter
shows the distance traveled since it
was last set to zero with the reset knob.
The tripmeter can be used to estimate
the distance that can be traveled with a
full tank of fuel. This information will en-
able you to plan future fuel stops.
1.
Tripmeter reset knob
2. Odometer
3. Tripmeter