2006 Yamaha Motorsports Apex Mountain Owners Manual - Page 97
2006 Yamaha Motorsports Apex Mountain Manual
Page 97 highlights
8. Start the engine. 9. Disconnect the black (-) jumper cable from the black (-) connecting lead, and then pull the cover completely over the lead terminal. 10. Disconnect the black (-) jumper cable from the negative (-) terminal of the booster battery. 11. Disconnect the red (+) jumper cable from the positive (+) terminal of the booster battery. 12. Disconnect the red (+) jumper cable from the red (+) connecting lead, and then pull the cover completely over the lead terminal. 13. Install the red (+) connecting lead into the lead holder. 14. Install the right side cover and the shroud. 4. Seized engine ...Seizure is caused by poor lubrication, inadequate fuel, or an air leak-Ask a Yamaha dealer to inspect. D. Engine power is low 1. Low coolant temperature indicator light is flashing ...Warm the engine up. 2. Faulty spark plugs ...Clean or replace the spark plugs. 3. Improper fuel flow ...See A.1. above. 4. Incorrect V-belt clutch settings for altitude or conditions ...Ask a Yamaha dealer to inspect. E. Engine constantly backfires or misfires 1. Faulty spark plugs ...Replace the spark plugs. 2. Clogged fuel system ...See A.1. above. 3. Malfunctioning T.O.R.S...See A.2. above. F. Engine overheats 1. Insufficient coolant ...Add coolant. 2. Air in cooling system ...Bleed the cooling system or ask a Yamaha dealer to inspect. 3. Leaking coolant ...Ask a Yamaha dealer to inspect. G. Snowmobile does not move 1. Malfunctioning V-belt clutch ...Ask a Yamaha dealer to inspect. 2. Drive track does not move ...Foreign object is caught in the drive track, or slide runners have melted to the slide metal due to lack of lubrication. 3. Tight, loose, or broken drive chain ...Ask a Yamaha dealer to inspect. WARNING @ Be sure to pull the lead covers back over the terminals completely. If the terminals are exposed, they could come into contact with the frame or a metal part of the snowmobile and this can cause electrical system damage or A FIRE HAZARD. @ NOTE: @ Make sure that both the red (+) connecting lead and the black (-) connecting lead are seated securely in the lead holders. @ C. Electric starter does not operate or operates slowly 1. Engine stop switch is pushed in ...Pull it out. 2. Faulty wire connections ...Check connections or ask a Yamaha dealer to inspect. 3. Discharged battery...Charge battery or see B above. 9-3