2007 Yamaha Motorsports Grizzly 700 FI Auto. 4x4 Exploring Edition Owners Manu - Page 53
2007 Yamaha Motorsports Grizzly 700 FI Auto. 4x4 Exploring Edition Manual
Page 53 highlights
ECB00822 G CAUTION: The coolant temperature warning light and engine trouble warning light should come on, then go off. The EPS warning light should come on, then go off when the engine is started. If a warning light does not go off, see page 4-2 for the corresponding warning light circuit check. 2. Apply the brake pedal, and then shift the drive select lever into the neutral or park position. The corresponding indicator light should come on. If the indicator light does not come on, have a Yamaha dealer check the electrical circuit. NOTE: This model is equipped with an ignition circuit cutoff system. The engine can be started under the following conditions: G The drive select lever is in the neutral or park position. The rear brake lever or brake pedal is applied with the drive select lever in any position. However, it is recommended to shift into the neutral or park position before starting the engine. 3. Apply the rear brake lever or brake pedal. 4. Completely close the throttle lever and start the engine by pushing the start switch. NOTE: If the engine fails to start, release the start switch, then push it again. Pause a few seconds before the next attempt. Each cranking should be as short as possible to preserve battery energy. Do not crank the engine more than 10 seconds on each attempt. 5. Continue warming up the engine until it idles smoothly. ECB00160 6 CAUTION: For maximum engine life, always warm the engine up before starting off. Never accelerate hard when the engine is cold! NOTE: The engine is warm when it responds normally to the throttle. 6-2