2007 Yamaha Motorsports Road Star Owners Manual - Page 60
2007 Yamaha Motorsports Road Star Manual
Page 60 highlights
PERIODIC MAINTENANCE AND MINOR REPAIR 3. If the oil is below the brim of the check hole, remove the oil filler cap, add sufficient oil of the recommended type to raise it to the correct level, and then install the oil filler cap. 4. Install the oil check bolt, and then tighten it to the specified torque. Tightening torque: Transfer case oil check bolt: 7.5 Nm (0.75 m·kgf, 5.4 ft·lbf) Tightening torque: Transfer case oil drain bolt: 17.5 Nm (1.75 m·kgf, 12.7 ft·lbf) To change the transfer case oil 1. Place an oil pan under the transfer case to collect the used oil. 2. Remove the drain bolt and the check bolt to drain the oil from the transfer case. 4. Remove the oil filler cap, add the specified amount of the recommended transfer case oil, and then install and tighten the oil filler cap. Recommended transfer case oil: See page 8-1. Oil quantity: 0.40 L (0.42 US qt) (0.35 Imp.qt) ECA10870 CAUTION: 6 1. Transfer case oil filler cap 2. Transfer case oil level check bolt Make sure that no foreign material enters the transfer case. 5. Start the engine and let it idle for several minutes while checking the transfer case for oil leakage. If oil is leaking, immediately turn the engine off and check for the cause. 1. Transfer case oil drain bolt 3. Install the drain bolt and the check bolt, and then tighten the drain bolt to the specified torque. 1. Transfer case oil check hole 6-14