2008 Yamaha Motorsports Phazer Owners Manual - Page 44

2008 Yamaha Motorsports Phazer Manual

Page 44 highlights

Operation etc. If snow coverage is not sufficient, stay on trails to avoid impact damage to the drive track. G Studded track In general, track life will be shortened when studs are installed. Drilling stud holes into the drive track will cut the internal fibers, which weakens the track. Avoid spinning the drive track. Studs may catch on an object and pull out of the track, leaving tears and damage around the already weakened area. To minimize possible damage, consult your stud manufacturer for installation and stud pattern recommendations. Yamaha does not recommend track studding. ESU11360 G G G Keep the right hand on the right handlebar grip for steering, and grip the strap with the left hand to shift weight uphill for balance during traverse riding. Ride cautiously while using the strap. Do not accelerate or decelerate abruptly while holding onto the strap. Do not use the strap to lift the snowmobile. Do not use the strap as a mounting point for cargo or accessories. ESU11401 Driving EWS00300 WARNING Be sure to read the "SAFETY INFORMATION" section on page 1 and the "Riding your snowmobile" section on page 34 carefully before operating the snowmobile. Strap (PZ50MT) The strap should be used only by experienced operators to assist them when traverse (sidehill) riding. NOTE: Make sure that the engine is warmed up enough before riding. 1. While the engine is idling, select the desired operating position by pressing the drive select switch. Make sure that the drive "D" indicator light or the reverse "R" indicator light flashes, and then remains on. Once the indicator light for the selected position remains on, the snowmobile can be driven. 1. Strap EWS00290 WARNING Improper use of the strap on the handlebar can result in severe injury or death. G Use the strap only as an operator grip point when needed to shift weight uphill to maintain balance during traverse (side-hill) riding. Only experienced operators should traverse slopes steep enough to require strap use. 38

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92

Operation
38
etc. If snow coverage is not sufficient, stay on
trails to avoid impact damage to the drive
track.
Studded track
In general, track life will be shortened when
studs are installed. Drilling stud holes into the
drive track will cut the internal fibers, which
weakens the track. Avoid spinning the drive
track. Studs may catch on an object and pull
out of the track, leaving tears and damage
around the already weakened area. To mini-
mize possible damage, consult your stud
manufacturer for installation and stud pattern
recommendations.
Yamaha does not recommend track stud-
ding.
ESU11360
Strap (PZ50MT)
The strap should be used only by experienced
operators to assist them when traverse (side-
hill) riding.
WARNING
EWS00290
Improper use of the strap on the handlebar
can result in severe injury or death.
Use the strap only as an operator grip
point when needed to shift weight uphill
to maintain balance during traverse
(side-hill) riding. Only experienced oper-
ators should traverse slopes steep
enough to require strap use.
Keep the right hand on the right handle-
bar grip for steering, and grip the strap
with the left hand to shift weight uphill
for balance during traverse riding.
Ride cautiously while using the strap.
Do not accelerate or decelerate abruptly
while holding onto the strap.
Do not use the strap to lift the snowmo-
bile.
Do not use the strap as a mounting point
for cargo or accessories.
ESU11401
Driving
WARNING
EWS00300
Be sure to read the “SAFETY INFORMA-
TION” section on page 1 and the “Riding
your snowmobile” section on page 34
carefully before operating the snowmo-
bile.
NOTE:
Make sure that the engine is warmed up
enough before riding.
1.
While the engine is idling, select the de-
sired operating position by pressing the
drive select switch. Make sure that the
drive “D” indicator light or the reverse “R”
indicator light flashes, and then remains
on. Once the indicator light for the select-
ed position remains on, the snowmobile
can be driven.
1. Strap