2008 Yamaha Motorsports RS Vector L-TX Owners Manual - Page 78
2008 Yamaha Motorsports RS Vector L-TX Manual
Page 78 highlights
Storage ESU12410 ECS00680 CAUTION: Long-term storage requires some preventive procedures to guard against deterioration. Do not attempt to store the snowmobile by simply starting the engine occasionally during the storage period. This can cause more harm than good! Moisture and acids form during combustion which can actually increase the chance for corrosion damage during the storage period. Cleaning Thoroughly clean the snowmobile, inside and out, to remove the corrosive salts and acids that can accumulate. Use Yamaha Mud, Grease, and Engine Cleaner, or an equivalent product, to loosen mud, grease, and grime. Wash with mild soap, then rinse and dry completely. Surface protection Apply a coat of wax to painted surfaces. Apply suitable protectants to the exterior of the engine, drive track, and to other metal, plastic, and rubber parts. Lubrication Lubricate moving parts, suspension linkage, and pivot points. Use the grease or lubricant specified in the MAINTENANCE section, or Yamaha Lube-Zall general-purpose lubricant. Proper lubrication fights corrosion while it reduces friction. Battery EWS00610 WARNING G Fuel system Add Yamaha Fuel Stabilizer and Conditioner, or an equivalent stabilizer, to the fuel tank to help prevent fuel oxidation and gum and varnish deposits, and to inhibit corrosion in the fuel system and carburetor. In areas where oxygenated fuel (gasohol) is used, completely drain the fuel system. Consult a Yamaha dealer if further information is needed. G G G Engine Proper storage of the engine is essential to prevent costly rust and corrosion damage to internal engine components. This is more important in areas where oxygenated fuel (gasohol) is used, because the alcohol content in the fuel increases the chance for water to enter the engine. Use Yamaha Stor-Rite Engine Fogging Oil, or an equivalent fogging oil, to protect both the combustion chamber and crankshaft from corrosion. An alternate method is to remove the air filter case and squirt oil into the carburetor throats while the engine is running. G Never smoke around the battery while it is being charged. Sparks may ignite the hydrogen gas created by the battery. Disconnect the negative lead first, then the positive lead from the battery. Connect the positive lead first, then the negative lead to the battery when installing the battery. Never connect the battery to or disconnect it from the snowmobile while it is being charged. Sparks may ignite the hydrogen gas created by the battery. Make sure that the battery terminals are tight. Remove the battery from the snowmobile. Store it in a cool, dry place that is above 0 °C (32 °F), but less than 30 °C (90 °F). Check the condition of the battery once a month, and charge it as necessary. ECS00690 CAUTION: G Always keep the battery charged. Storing a discharged battery can cause permanent battery damage. 72