2008 Yamaha Motorsports RS Venture GT Owners Manual - Page 57
2008 Yamaha Motorsports RS Venture GT Manual
Page 57 highlights
Periodic maintenance ESU12050 V-belt EWS00400 WARNING G G Make sure that the drive guard is tightened securely before operating the snowmobile. Never run the engine with the V-belt or drive guard removed. 1. "COLD LEVEL" mark 2. Coolant reservoir cap The V-belt should be checked before each ride. To check the V-belt 1. Open the shroud and remove the drive guard. 2. Check the V-belt for wear and damage. Replace if necessary. Recommended antifreeze: High-quality ethylene glycol antifreeze containing corrosion inhibitors Antifreeze and water mixing ratio: 3:2 Total amount: 5.20 L (5.50 US qt) (4.58 Imp.qt) 2. Start the engine and add coolant until the coolant level does not go down, and then stop the engine. Fill the coolant reservoir with coolant until it reaches the "COLD LEVEL" mark. Install the coolant reservoir cap. Check for any coolant leakage. 1. V-belt wear limit New V-belt width: 34.1 mm (1.34 in) V-belt wear limit width: 32.5 mm (1.28 in) 3. Install the drive guard and close the shroud. To replace and adjust the V-belt EWS00410 3. 4. 5. NOTE: If you find any leaks, consult a Yamaha dealer. G WARNING Never run the engine with the V-belt or drive guard removed. When installing the new V-belt, make sure that it is positioned properly. Otherwise, the V-belt clutch engagement G 51