2008 Yamaha Motorsports V Star Silverado Owners Manual - Page 79
2008 Yamaha Motorsports V Star Silverado Manual
Page 79 highlights
PERIODIC MAINTENANCE AND MINOR REPAIR EAU25511 To install the rear wheel 1. Install the rear wheel, wheel axle, final gear case, and drive shaft by pushing the wheel forward and guiding the drive shaft into the middle gear universal joint. 7. Tighten the axle nut, the final gear case bolts and the brake torque rod nuts to the specified torques. Tightening torques: Axle nut: 92 Nm (9.2 m·kgf, 66 ft·lbf) Final gear case bolt: 74 Nm (7.4 m·kgf, 53 ft·lbf) Brake torque rod nut: 20 Nm (2.0 m·kgf, 14 ft·lbf) 1. Bolt 2. Final gear case 7. Lift the rear wheel off the ground according to the procedure on page 6-35. 8. While supporting the drive shaft, pull the rear wheel back to remove the following parts as an assembly: wheel, wheel axle, final gear case, and drive shaft. NOTE: Make sure to support the drive shaft as it is being pulled out. 8. Adjust the brake pedal free play. (See page 6-23.) EWA10660 WARNING 1. Middle gear universal joint 2. Drive shaft After adjusting the brake pedal free play, check the operation of the brake light. 6 2. Install the final gear case bolts. 3. Install the brake rod onto the brake camshaft lever, and then install the brake pedal free play adjusting nut onto the brake rod. 4. Install the brake torque rod bolt and nut at the brake shoe plate. 5. Install the panel. 6. Lower the rear wheel so that it is on the ground. 6-38